B & I Dash Trim Installation Instructions

BACK TO DASH TRIM KIT PAGE

Chevrolet FS Van 97 Molded Dash Trim

Before you begin installation, make certain you have received the correct kit (reference parts received with shadow sheet) and make sure to read all installation instructions.

For the best results, the temperature of the dash and the dash pieces should be approximately 70°F (21°C). In colder conditions, use a heat gun or hair dryer to warm part surfaces to the ideal temperature.

Dash Trim Instructions

STEP 1: CLEAN THE SURFACE
Caution! Factory part surface MUST be completely dry and free of contaminants for your dash kit to adhere properly!

Use the alcohol pads included in your kit to wipe all surfaces clean. In many cases, you may need to repeat this step more than once.

STEP: 2 LIFT PART FROM BOX

Identify the location on the dash where each piece in your kit is to be applied. In preparation for the installation of each piece, simply lift it off the packing board.

Caution! To insure the strongest adhesion, avoid making direct contact with the adhesive surface.

Dash Trim Instructions STEP 3: INSTALL PART
Starting with any of the larger pieces and beginning from any edge, apply the piece onto the dash.

Caution! Do not press firmly into place until you are comfortable with the parts position.

If the piece is not positioned properly, simply lift it up and reinstall to achieve the desired fit.

If you are in a colder than recommended installation climate, gently warm each piece with a heat gun or hair dryer to insure proper adhesion.

BACK TO DASH TRIM KIT PAGE